LEXUS RX 300

1998 — 2003 of release

Repair and car operation



RX 300 Lexus
+ Lexus RX-300 Cars
+ Governing bodies and operation receptions
+ Settings and routine maintenance of the car
+ Engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ the Power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Automatic transmission and interaxal differential
+ Transmission line
+ Brake system
- Suspension bracket and steering
   General information
   - Forward suspension bracket
      Removal, dismantling, assembly and installation of a nave and rotary fist
      Removal, dismantling assembly and installation of a rack of a suspension bracket
      Removal and installation of the bottom lever of a suspension bracket
      Check and replacement of a spherical support of a suspension bracket
      Removal, installation and check of the stabilizer of a suspension bracket
   + Back suspension bracket
   + Steering
   + suspension bracket Geometry
+ Body
+ Onboard electric equipment
+ Schematic diagrams of electric connections




Removal, installation and check of the stabilizer of a suspension bracket

Components of installation of the stabilizer of a forward suspension bracket

1 — a stabilizer Rack
2 — the Bracket
3 — the Plug

4 — a plug Stopper
5 — the Bracket No. 2
6 — the Holder of a stopper


 PERFORMANCE ORDER

  1. Remove both lobbies of a wheel.
  2. Turn out on two nuts from each party and remove both racks of the stabilizer (serially).

If hinges are turned together with nuts, hold them a six-sided key on 5 mm.

  1. Serially turn out on two bolts and remove brackets and stabilizer plugs.
  2. Remove the stabilizer.
  3. By means of a screw-driver remove the holder of a stopper of the plug, and then remove a stopper.
  1. Clamp in a vice the hinge of a rack of the stabilizer and shake its tip forward-back about five times.
  1. Continuously tightening a dinamometrichesky key a hinge nut with a speed 1 turn for 2 ÷ 4 with, consider key indications on the fifth turn and compare them to requirements of Specifications of Head the Suspension bracket and a steering. If necessary replace a stabilizer rack.
  2. Installation is made upside-down. The plug of the stabilizer establish outside of a plug stopper; the stabilizer establish the marked paint the party to the left board of the car.