RX 300 Lexus + Lexus RX-300 Cars + Governing bodies and operation receptions + Settings and routine maintenance of the car + Engine - Systems of cooling of the engine, heating, ventilation and air conditioning - System of cooling of the engine General information and precautionary measures Removal, check and installation of the water pump Removal, check and thermostat installation Check of components of system of cooling Removal and installation of a radiator and fans + Systems of heating, ventilation and air conditioning + the Power supply system and production of the fulfilled gases + Systems of electric equipment of the engine + Automatic transmission and interaxal differential + Transmission line + Brake system + Suspension bracket and steering + Body + Onboard electric equipment + Schematic diagrams of electric connections
|
Removal, check and installation of the water pump
Bolts of fastening of the water pump
The water pump is located under a cover of No. 3 belts of a drive of GRM and fastens to the block of cylinders four bolts and two nuts.
|
- Empty cooling system (see. The section Replacement of cooling liquid (OZh)).
- Remove a fairing of a windscreen and the top strut of an impellent compartment (see. Head Body).
- Remove a belt of a drive of GRM, its cogwheels and a roller No. 2 (see. Section Removal, check and installation of a belt of a drive of GRM of its natyazhitel, pulley and cogwheel of a cranked shaft, cogwheels of camshafts and intermediate rollers).
- Uncover No. 3 belts of a drive of GRM (see. Section Removal, dismantling, check, assembly and installation of a head of cylinders and its components).
- Turn out fixture of the water pump and remove it together with laying.
- Examine a control opening in the pump case on existence of leaks and if necessary replace the water pump.
- Rotating a roller of the water pump a hand, check smoothness and ease of a course of its bearing. If necessary replace the water pump.
- Having used a case, check components of a drive of GRM (see. Section Removal, check and installation of a belt of a drive of GRM of its natyazhitel, pulley and cogwheel of a cranked shaft, cogwheels of camshafts and intermediate rollers).
- Installation is made as it should be, the return to an order of dismantle of components. Use new laying of the pump, tighten fixture with demanded efforts.
|
|
|
At installation of laying do not oil it. |
|
|