LEXUS RX 300

1998 — 2003 of release

Repair and car operation


RX 300 Lexus
+ Lexus RX-300 Cars
+ Governing bodies and operation receptions
+ Settings and routine maintenance of the car
+ Engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ the Power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
- Automatic transmission and interaxal differential
   General information
   Search of malfunctions - the general information
   Replacement of sensors
   Removal and installation of assembly of AT valves
   Checks and AT adjustments
   Removal and installation of a cooler of ATF
   Removal and installation of assembly of the lever of the selector of AT modes
   Removal and AT installation
+ Transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Schematic diagrams of electric connections



Removal and AT installation

Components of AT installation (U140F)

1 — the Plait and electroconducting sockets
2 — a weight Cable
3 — the Right support
4 — the Right rack of an exhaust pipe
5 — Transmission

6 — an opening Stopper for pressure measurement in AT lines
7 — the Starter
8 — the Left rack of an exhaust pipe
9 — the Bottom cover of a driving disk


 PERFORMANCE ORDER

  1. Remove the power unit from the car (see. Section Removal and engine installation, check of support).
  2. Remove a starter (see. Section Removal and starter installation).
  3. Turn out bolts and nuts and remove the left and right racks of an exhaust pipe.
  4. Turn out 5 bolts and remove the right support.
  5. Turn out 2 bolts the bottom cover of a driving disk.
  6. Turning a cranked shaft, turn out bolts of fastening of the coupling of the hydrotransformer.
  1. Turn out three bottom bolts of fastening of AT.
  1. Turn out bolts of fastening of cables of weight to AT and disconnect these cables.
  2. Disconnect from AT the following sockets:
    • P/N mode Д/В socket;
    • Electroconducting socket Ý/m valve;
    • Socket of the sensor of entrance turns of the hydrotransformer;
    • Socket of the sensor of speed of an auxiliary gear wheel.
  3. Liberate an electroconducting plait from holders.
  4. Turn out 5 top bolts of fastening of AT and disconnect a weight cable.
  5. Remove AT.
  6. Installation is made upside-down. Tighten fixture with demanded effort.
  7. After installation adjust a drive of gear shifting and Д/В the P/N modes. Fill AT with ATF liquid, check its level. Make a trial trip on the car.