LEXUS RX 300

1998 — 2003 of release

Repair and car operation



RX 300 Lexus
+ Lexus RX-300 Cars
+ Governing bodies and operation receptions
+ Settings and routine maintenance of the car
+ Engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ the Power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Automatic transmission and interaxal differential
+ Transmission line
- Brake system
   General information and security measures
   Removal, installation and check of pedals of brake system
   Check of brake system via the socket of the module of management
   Removal and installation of the tank and main brake cylinder (GTTs)
   Removal, check and installation of the amplifier of brakes
   Replacement of brake shoes
   Removal, dismantling, check, assembly and installation of supports of brake mechanisms
   Dismantling, check and assembly of the parking brake
   Check of the valve of distribution of brake effort
   Removal and installation of the activator of brakes
   Removal and installation of wheel sensors
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Schematic diagrams of electric connections




Removal and installation of the tank and main brake cylinder (GTTs)

Components of installation and GTTs assembly

1 — Collars
2 — GTTs tank Hoses
3 — Laying
4 — the Reception union
5 — the Piston No. 1
6 — the Piston No. 2

7 — the Spring
8 — the GTTs Case
9 — the Pin
10 — Consolidation
11 — the Tank
12 — the Filter
13 — the Cover


 PERFORMANCE ORDER

  1. Remove air purifier assembly (see. Head of the Power supply system and production of the fulfilled gases).
  2. Pump out from GTTs brake liquid by means of a syringe or a sprintsovka.
  3. Separate the Д/В socket of low level of brake liquid.
  4. Put adjusting labels on hoses of the GTTs tank and collars, weaken collars and remove hoses from the tank.
  5. Turn out a bolt and remove assembly of the tank of brake liquid.
  6. Put adjusting labels on hoses of the GTTs tank and collars, weaken collars and remove hoses from GTTs.
  7. Disconnect from the tank 2 brake tubes.
  8. Turn out two nuts and remove GTTs together with laying.
  9. If necessary disassemble GTTs.
  10. Before installation clear GTTs and the tank the compressed air and adjust length of a press rod of the amplifier of brakes (see. Section Removal, check and installation of the amplifier of brakes).
  11. After installation fill the tank with brake liquid, pump over brake system and check it on leaks.
  12. Adjust a pedal of a working brake (see. Section Check and adjustment of a course of pedals of the working and parking brake).