LEXUS RX 300

1998 — 2003 of release

Repair and car operation



RX 300 Lexus
+ Lexus RX-300 Cars
+ Governing bodies and operation receptions
+ Settings and routine maintenance of the car
+ Engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ the Power supply system and production of the fulfilled gases
- Systems of electric equipment of the engine
   + ignition and engine management Systems
   + Diagnostics of systems of electronic control and diagnostic equipment
   - Charge and start systems
      General information
      The storage battery - the general information, recommendations about service
      Charge system - general information and security measures
      Check of system of a charge
      Removal and generator installation
      System of start of the engine - the general information
      Removal and starter installation
+ Automatic transmission and interaxal differential
+ Transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Schematic diagrams of electric connections




Removal and generator installation

Details of installation of the generator

1 — the Flat washer
2 — Sharnirny a bolt
3 — the Fixing bolt of adjustment of a tension of a driving belt
4 — a generator Wire

5 — the generator Socket
6 — the Generator
7 — the Bolt of adjustment of a tension of a driving belt of the generator
8 — the Driving belt of the generator and the To/in compressor

Details of assembly of the L3B generator

1 — a generator Washer
2 — a bearing Cover
3 — the Back bearing
4 — the Rotor
5 — the Forward bearing
6 — the Holder
7 — the Cover from a drive

8 — the Pulley
9 — the Back sealing plate
10 — the Forward sealing plate
11 — a contact Insulator
12 — Shchyotkoderzhatel
13 — the Back cover
14 — winding Assembly

Details of assembly of the SC1 generator

1 — the Washer the generator
2 — a bearing Cover
3 — the Back bearing
4 — the Rotor
5 — the Forward bearing
6 — the Holder
7 — Stator (a cover from a drive)
8 — the Pulley
9 — the Plug
10 — the Cover of a shchyotkoderzhatel

11 — a contact Insulator
12 — the Sealing plate
13 — an electroconducting Clip
14 — the Cover from the rectifier
15 — the Back cover
16 — Shchyotkoderzhatel
17 — a tension Regulator
18 — the Holder of the rectifier
19 — the Rubber insulator


 PERFORMANCE ORDER

  1. Disconnect a negative wire from the battery.
  2. Remove a driving belt (see. Head of Control and routine maintenance of the car).
  3. Separate the generator socket.
  4. Give a nut and disconnect from the generator a wire.
  5. Disconnect an electroconducting plait from the holder.
  6. Turn out a sharnirny bolt, remove the flat washer, fixing bolt of adjustment of a tension of a driving belt and the generator.
  7. Installation is made as it should be, the return to an order of dismantle of components.