LEXUS RX 300

1998 — 2003 of release

Repair and car operation


RX 300 Lexus
+ Lexus RX-300 Cars
+ Governing bodies and operation receptions
+ Settings and routine maintenance of the car
+ Engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ the Power supply system and production of the fulfilled gases
- Systems of electric equipment of the engine
   + ignition and engine management Systems
   + Diagnostics of systems of electronic control and diagnostic equipment
   - Charge and start systems
      General information
      The storage battery - the general information, recommendations about service
      Charge system - general information and security measures
      Check of system of a charge
      Removal and generator installation
      System of start of the engine - the general information
      Removal and starter installation
+ Automatic transmission and interaxal differential
+ Transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Schematic diagrams of electric connections



Removal and starter installation

Details of installation of a starter

Details of assembly of a starter

1 — Ogranichitelno a ring
2 — the Spring
3 — the Plate a spring
4 — the Lock plug
5 — the Gear wheel
6 — the Forward cover
7 — Obgonnaya the coupling
8 — the Spring
9 — a drive Shaft
10 — Assembly of a forward cover and the obgonny coupling
11 — the Intermediate gear wheel
12 — the Bearing

13 — the Returnable spring
14 — the Steel ball
15 — the Traction relay
16 — the Forward bearing
17 — the Anchor
18 — the Back bearing
19 — the Sealing ring
20 — the Case with a field winding
21 — the Sealing ring
22 — the Back cover
23 — Shchyotkoderzhatel
24 — the Sealing ring
25 — the Boot


 PERFORMANCE ORDER

  1. Disconnect a negative wire from the battery.
  2. Remove an air purifier (see. Head of the Power supply system and production of the fulfilled gases).
  3. Separate the starter socket.
  4. Turn out a nut and disconnect a starter wire.
  5. Turn out two fixing bolts and remove a starter.
  6. Installation is made upside-down.