LEXUS RX 300

1998 — 2003 of release

Repair and car operation


RX 300 Lexus
+ Lexus RX-300 Cars
+ Governing bodies and operation receptions
+ Settings and routine maintenance of the car
+ Engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ the Power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Automatic transmission and interaxal differential
+ Transmission line
+ Brake system
- Suspension bracket and steering
   General information
   + Forward suspension bracket
   - Back suspension bracket
      Removal, dismantling, assembly and installation of a nave of a back wheel
      Removal, dismantling, assembly and installation of a rack of a suspension bracket
      Removal and installation of the stabilizer of a suspension bracket
      Removal and installation of levers of a back suspension bracket
   + Steering
   + suspension bracket Geometry
+ Body
+ Onboard electric equipment
+ Schematic diagrams of electric connections



Removal and installation of levers of a back suspension bracket

Components of installation of levers of a back suspension bracket

1 — the Back stretcher
2 — the Holder
3 — the Cross-section lever No. 1
4 — the Clown of adjustment of convergence of back wheels
5 — the Cross-section lever No. 2

6 — the Cable of a drive of the parking brake
7 — the Longitudinal lever
8 — Draught of the sensor of adjustment of an inclination of headlights
9 — the Washer


 PERFORMANCE ORDER

  1. Remove a back wheel.
  2. Remove the central and back sections of an exhaust pipe.
  3. Turn out a bolt and remove from a body an arm of a cable of the parking brake.
  4. At the corresponding complete set turn out a nut and disconnect draft of the sensor of adjustment of an inclination of headlights from cross-section draft No. 2 of a back suspension bracket.
  5. Turn out two bolts, a nut and remove the longitudinal lever of a suspension bracket.
  6. Put adjusting labels on the clown of adjustment of convergence of back wheels and on a stretcher.
  7. Turn out a bolt and a nut, remove the clown and disconnect cross-section draft No. 2 from a stretcher.
  8. Turn out a bolt and a nut of fastening of cross-section draft No. 2 for stupichny assembly and remove draft.
  9. Turn out a bolt and a nut of fastening of cross-section draft No. 1 for stupichny assembly and disconnect from it draft.
  10. Weaken an adjusting bolt of the cross-section lever No. 1 to a back stretcher.

Do not remove a bolt entirely.

  1. Prop up a back stretcher a jack, turn out 4 nuts, 2 bolts and remove two holders from a back stretcher.
  2. Lower a jack, completely turn out a bolt of fastening of the cross-section lever No. 1 to a back stretcher and remove the lever.
  3. Installation is made upside-down. In summary check and if necessary adjust corners of installation of back wheels.