LEXUS RX 300

1998 — 2003 of release

Repair and car operation



RX 300 Lexus
+ Lexus RX-300 Cars
+ Governing bodies and operation receptions
+ Settings and routine maintenance of the car
+ Engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ the Power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Automatic transmission and interaxal differential
+ Transmission line
+ Brake system
- Suspension bracket and steering
   General information
   + Forward suspension bracket
   + Back suspension bracket
   + Steering
   - Suspension bracket geometry
      Corners of installation of wheels of the car - the general information
      Check and adjustment of corners of installation of forward wheels
      Check and adjustments of corners of installation of back wheels
+ Body
+ Onboard electric equipment
+ Schematic diagrams of electric connections




Check and adjustment of corners of installation of forward wheels

Check

Check of geometrical parameters of a suspension bracket is made at the special stand in the conditions of a car-care center workshop. Data for check and adjustment of wheels are provided in Specifications of Head the Suspension bracket and a steering.


 PERFORMANCE ORDER

  1. Measure distances from the earth to the center of a forward bolt of fastening of the bottom lever of a forward suspension bracket and to the center of a forward bolt of fastening of the longitudinal lever of a back suspension bracket. Compare the received values to requirements of Specifications of Head the Suspension bracket and a steering.

Heads given in Specifications the Suspension bracket and a steering are given for tires P225/70R16.

  1. Establish the car on the measuring stand and check disorder corners, выбега and an inclination of an axis of turn of wheels. If at normal disorder corners выбега and an inclination of an axis of turn of wheels do not correspond to requirements of Specifications of Head the Suspension bracket and a steering, check suspension bracket components on existence of damages and wear.
  1. Check convergence of wheels.
  1. Turn against the stop a steering wheel and measure limiting angles of rotation of wheels. At unsatisfactory results of check check lengths of the left and right steering drafts.

Disorder adjustment

After adjustment of disorder check convergence of wheels. At adjustment of a corner of disorder try to expose its average value.


 PERFORMANCE ORDER

  1. Remove forward wheels and holders of sensors of speed of ABS.
  2. Give two bottom nuts of fastening of a rack of a forward suspension bracket to a rotary fist.
  1. Grease a carving of nuts (1) and (2) impellent oil and temporarily establish them.
  1. Adjust disorder pressing or delaying the lower part of a rack in the corresponding direction.
  2. Tighten nuts with effort of 210 Nanometers. Establish forward wheels.
  3. Again check a disorder corner.
  4. The range of adjustment of the established bolts makes from 6' to 30'. If necessary it is possible to pick up adjusting bolts according to the table provided below.

  1. After an otdavaniye of nuts replace a bolt (ы) on picked up (if necessary).

Convergence adjustment

 PERFORMANCE ORDER

  1. About protective covers also give lock-nuts of tips of steering drafts.
  1. Turn steering drafts on the quantity of turns necessary for installation of average spetsifikatsionny value of convergence.
  1. Make sure that residual lengths of the right and left steering drafts differ no more, than on 1.5 mm.
  1. Tighten lock-nuts of tips of steering drafts with effort of 74 Nanometers. Also establish protective covers.