LEXUS RX 300

1998 — 2003 of release

Repair and car operation



RX 300 Lexus
+ Lexus RX-300 Cars
+ Governing bodies and operation receptions
+ Settings and routine maintenance of the car
+ Engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ the Power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Automatic transmission and interaxal differential
- Transmission line
   General information
   Removal and driveshaft installation
   Removal, dismantling, assembly and installation of forward power shafts
   Removal, dismantling, assembly and installation of back power shafts
   Replacement of a forward epiploon of back differential
   Replacement of lateral epiploons of back differential
   Removal and installation of the case of back differential, differential dismantling
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Schematic diagrams of electric connections




Removal and installation of the case of back differential, differential dismantling

Components of installation of back differential

1 — the Damper
2 — the Back stretcher
3 — the Power shaft

4 — the Holder
5 — Back differential
6 — the Back cross-section beam
7 — the Driveshaft

Components of assembly of back differential

1 — Planetary differential
2 — Differential of limited sliding
3 — the Persistent washer
4 — the Lock pin
5 — the Axis of satellites
6 — the Lateral gear wheel
7 — the Satellite
8 — the Washer
9 — the Lateral bearing
10 — the Conducted gear wheel
11 — a differential Box
12 — the Lock plate
13 — the Stopper сапуна
14 — Maslootrazhatel
15 — a bearing Cover

16 — the Lock ring
17 — the differential Case
18 — Laying
19 — the Casing of the holder of differential
20 — the Epiploon
21 — the Leading gear wheel
22 — the Back bearing
23 — the Lateral drive
24 — the Boot
25 — the Stopper of a jellied opening
26 — the Cover of a casing of the holder of differential
27 — the Connecting flange
28 — Maslootrazhatel
29 — the Forward bearing
30 — Prostavka of the bearing
31 — the Drain stopper


 PERFORMANCE ORDER

  1. Remove the driveshaft and power shafts, previously having reliably propped up them (see. Sections Removal and installation of the driveshaft and Removal, dismantling, assembly and installation of back power shafts).
  2. Lower not enough differential.
  3. Remove the central and back sections of an exhaust pipe.
  1. Prop up differential a jack, give 3 fixing bolts and remove a damper.
  1. Weaken 2 bolts and prop up a back stretcher.
  1. Give 4 nuts and 2 bolts, remove 2 holders from a back stretcher.
  2. Lower differential together with a back stretcher.
  3. Completely turn out 5 released bolts, 2 nuts and remove differential.
  4. Turn out two bolts, nuts and remove a back cross-section beam from differential.
  5. It is recommended to charge dismantling of differential to the expert having the corresponding skills and experience. Data for check and assembly of back differential are provided in Specifications of Head the Transmission line.
  6. The box of differential with limited sliding is not subject to dismantling.
  7. Installation is made upside-down. Tighten connections with demanded efforts.