RX 300 Lexus + Lexus RX-300 Cars + Governing bodies and operation receptions + Settings and routine maintenance of the car + Engine + Systems of cooling of the engine, heating, ventilation and air conditioning + the Power supply system and production of the fulfilled gases + Systems of electric equipment of the engine - Automatic transmission and interaxal differential General information Search of malfunctions - the general information Replacement of sensors Removal and installation of assembly of AT valves Checks and AT adjustments Removal and installation of a cooler of ATF Removal and installation of assembly of the lever of the selector of AT modes Removal and AT installation + Transmission line + Brake system + Suspension bracket and steering + Body + Onboard electric equipment + Schematic diagrams of electric connections
|
Replacement of sensors Sensors of speed
|
- Disconnect a negative wire from the storage battery.
- Remove air purifier assembly (see. Head of the Power supply system and production of the fulfilled gases).
- Separate sockets of electroconducting of the sensor of entrance turns of the hydrotransformer and the sensor of speed of a secondary gear wheel, turn out bolts of fastening of sensors and remove sensors.
|
- Sensor of entrance turns of the hydrotransformer
|
|
- Sensor of speed of a secondary gear wheel
|
- Establish new sensors together with new sealing rings and tighten bolts of fastening of sensors with effort of 11 Nanometers.
|
|
Sensor of temperature of ATF
|
- Remove assembly of valves (see. Section Removal and installation of assembly of AT valves).
|
- Separate the electroconducting socket Ý/m the valve, turn out a bolt, remove a wire of the valve and remove the sensor of temperature of ATF.
|
- Establish the new sensor, tighten a fixing bolt with effort of 5.4 Nanometers and connect electroconducting.
|
|
Sensor switch of the P/N modes
|
- Remove the bottom protective casing of an impellent compartment.
|
- Separate the socket of electroconducting Д/В of the P/N modes. Give nuts, remove a washer and the lever of draft of switching of modes.
|
|
- Wring out a lock plate, turn out the bottom nut and remove a lock plate.
|
|
- Turn out bolts of fastening Д/В of the P/N modes and remove the sensor switch.
|
- Establish new Д/В and tighten bolts of its fastening with effort of 5.4 Nanometers.
- Tighten the bottom nut with effort of 6.9 Nanometers and fix it a lock washer, having bent its edges.
- Tighten the top nuts with demanded efforts and join the sensor socket.
- Check that the engine is started only at the lever of the AT selector established in the position "P" or "N". If necessary adjust Д/В (see. Section of Check and AT adjustment).
- Establish assembly of an air purifier and the bottom protective casing of an impellent compartment.
|
|
|
|