картинки зимние виды спорта

LEXUS RX 300

1998 — 2003 of release

Repair and car operation



RX 300 Lexus
+ Lexus RX-300 Cars
+ Governing bodies and operation receptions
+ Settings and routine maintenance of the car
+ Engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ the Power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Automatic transmission and interaxal differential
+ Transmission line
- Brake system
   General information and security measures
   Removal, installation and check of pedals of brake system
   Check of brake system via the socket of the module of management
   Removal and installation of the tank and main brake cylinder (GTTs)
   Removal, check and installation of the amplifier of brakes
   Replacement of brake shoes
   Removal, dismantling, check, assembly and installation of supports of brake mechanisms
   Dismantling, check and assembly of the parking brake
   Check of the valve of distribution of brake effort
   Removal and installation of the activator of brakes
   Removal and installation of wheel sensors
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Schematic diagrams of electric connections



Removal and installation of the activator of brakes

Components of installation and activator assembly

1 — the Broad tank of OZh
2 — activator Assembly
3 — GUR Tube
4 — the Activator

5 — the Holder
6 — Laying
7 — Loker of the right forward wheel arch
8 — the Arm of fastening of the activator


 PERFORMANCE ORDER

  1. Remove the right forward wheel and a loker of his arch.
  2. Turn out a bolt of fastening of the holder of a tube of GUR.
  3. Shift forward a broad tank of OZh and remove it to the holder.
  4. Separate the 4th socket and disconnect hoses from the activator of brakes.
  5. Disconnect from assembly of the activator of brakes of 6 brake tubes.
  6. Turn out two bolts and a nut and remove activator assembly.
  7. Turn out two nuts and remove the activator from an arm.
  8. Remove from the activator two holders and three laying.
  9. Installation is made upside-down.
  10. After installation fill the GTTs tank with brake liquid and pump over brake system (see. Section Replacement of brake liquid, pumping of brake system).