1998 — 2003 of release

Repair and car operation

RX 300 Lexus
+ Lexus RX-300 Cars
+ Governing bodies and operation receptions
+ Settings and routine maintenance of the car
+ Engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ the Power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Automatic transmission and interaxal differential
+ Transmission line
+ Brake system
+ Suspension bracket and steering
- Body
   - External equipment and body elements
      Removal and installation of the top strut of an impellent compartment
      Removal and installation of bumpers
      Removal and installation of a cowl, its lock and decorative reshyotka of a radiator
      Removal, installation, dismantling and assembly of a forward door and its components
      Removal, installation, dismantling and assembly of a back door and its components
      Removal, dismantling, assembly and installation of a door of a back and its components
      Removal and installation of cleaners and windscreen fairing
      Removal and installation of moldings
      Removal and spoiler installation
      Removal and installation of the top hatch
   + salon Equipment
+ Onboard electric equipment
+ Schematic diagrams of electric connections

Removal and installation of a cowl, its lock and decorative reshyotka of a radiator

Components of installation of a cowl

1 — a cowl Support
2 — the Cowl
3 — the Pillow
4 — the Decorative reshyotka of a radiator

5 — the Holding hook
6 — cowl Isolation
7 — the Lever of a holding hook
8 — Consolidation of a support of a radiator


  1. At installation of the cowl which is especially new, it is necessary to adjust its situation.

When using a centering bolt as a bolt of fastening of loops and the cowl lock the lock and a cowl it will not be possible to adjust. For adjustment replace aligning bolt with a usual bolt with a washer.

  1. For cowl adjustment in the horizontal plane give loopy bolts, expose a cowl in demanded situation and tighten bolts with effort of 13 Nanometers.
  2. Adjustment of height of a forward part of a cowl is made by rotation of its basic pillows.
  1. Turn out 8 bolts and remove the top casing of a support.
  1. Turn out two bolts and a nut and remove the cowl lock, previously having disconnected from it a driving cable.
  2. Grease rubbing parts of the lock of a cowl with universal greasing.
  1. Having by hand tightened bolts and a nut, adjust position of the lock of a cowl then tighten lock fixture with demanded effort.