LEXUS RX 300

1998 — 2003 of release

Repair and car operation


RX 300 Lexus
+ Lexus RX-300 Cars
+ Governing bodies and operation receptions
+ Settings and routine maintenance of the car
+ Engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ the Power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Automatic transmission and interaxal differential
+ Transmission line
+ Brake system
+ Suspension bracket and steering
- Body
   - External equipment and body elements
      Removal and installation of the top strut of an impellent compartment
      Removal and installation of bumpers
      Removal and installation of a cowl, its lock and decorative reshyotka of a radiator
      Removal, installation, dismantling and assembly of a forward door and its components
      Removal, installation, dismantling and assembly of a back door and its components
      Removal, dismantling, assembly and installation of a door of a back and its components
      Removal and installation of cleaners and windscreen fairing
      Removal and installation of moldings
      Removal and spoiler installation
      Removal and installation of the top hatch
   + salon Equipment
+ Onboard electric equipment
+ Schematic diagrams of electric connections



Removal and installation of cleaners and windscreen fairing

Components of installation of a fairing of a windscreen

1 — Consolidation between a cowl and a fairing
2 — Assemblies of levers and edges of screen wipers
3 — the Right lattice of a fairing
4 — the Left lattice of a fairing

5 — Э / the motor and drafts of levers of screen wipers
6 — the Socket э / the motor of screen wipers
7 — the Panel of a fairing of a windscreen


 PERFORMANCE ORDER

  1. Give 3 nuts and remove assemblies of levers and edges of screen wipers.
  2. Paste a protective tape on the lower part of a windscreen.
  3. Remove consolidation between a cowl and a fairing.
  4. Remove clips and both lattices of a fairing.
  5. Separate the socket э / the motor of screen wipers.
  1. Turn out 5 bolts and remove э / the motor with drafts of levers of screen wipers.
  1. Give a nut, put adjusting labels, turn out 3 bolts and remove э / the motor from assembly of drafts.
  1. Turn out 9 bolts and remove the fairing panel.
  2. Disconnect hoses from nozzles of washers and remove nozzles.
  3. Installation is made upside-down. Tighten fixture with demanded efforts.
  4. In conclusion of installation tighten nuts of fastening of levers of screen wipers by hand and include screen wipers on one cycle. Adjust positions of levers (see. The section condition Check, adjustment and replacement of brushes of screen wipers) also tighten nuts with demanded efforts.
  5. After installation check, that the top points of hit of streams of washing liquid on glass were in the areas designated on an illustration, and the bottom points – in a scope of screen wipers.

Check of nozzles of washers

A — 280 mm
B — 150 mm
C — 10 mm
D — 60 mm